EN Cleaning and maintaining the RS 5000
22 | RS 5000
Cleaning and maintaining the
RS 5000
To clean the wireless headphone system:
왘 Switch your wireless headphone system off and disconnect
the transmitter from the socket before cleaning.
왘 Clean the product only with a soft, dry cloth.
왘 Clean the charging contacts on the stethoset receiver and
in the charging compartment from time to time using e.g.
a cotton swab.
To clean the ear pads:
왘 Carefully remove the ear pads from the stethoset receiver.
왘 Clean the ear pads with warm soapy water and rinse thor-
oughly.
왘 Dry the ear pads.
왘 Put the ear pads back on the stethoset receiver.
CAUTION
Liquids can damage the electronics of the product!
Liquids entering the housing of the product can cause a short-
circuit and damage the electronics.
왘 Keep all liquids far away from the product.
왘 Do not use any solvents or cleansing agents.
For reasons of hygiene, you should replace your ear pads
from time to time. Spare ear pads in different materials
and forms are available from your Sennheiser partner.
RS_5000_570727_0117_PRT.book Seite 22 Montag, 10. Oktober 2016 2:52 14
To Next Page
Loading...
