Sennheiser TeamConnect Bar - Device-Dependent Network Set-Up

v1.0 | 6/21
Network Guide
TeamConnect Bar
Device-Dependent Network Set-Up
Depending on the model, the TC Bar offers various options for integrating the device into a network.
The following is an overview for quick orientation of outgoing use cases and for setting up preferred
network configurations.
The following network modes are available:
• Single Domain Mode (SDM)
• Dual Domain Mode (DDM)
• Split Mode (SM)
Use Cases Single Domain Mode Dual Domain Mode Split Mode Comments
Network Structure Description
1
• One network
• One IP address
• One network switch
f Configure both Dante and
control networks over one switch
f Use only one IP address for both
networks
f Control both networks over one
single network port of the TC Bar
X
For details see
„Single
Domain
Mode“
2
• Two separated networks
(Control and Dante) over
one cable
• Two different IP addresses
• One network switch
f Configure both Dante and
control networks over one switch
f Use two different IPs to address
the Control network and the
Dante network separately
f Control both networks over one
single network port of the TC Bar
X
For details see
„Dual
Domain
Mode“
3
• Two separated networks
(Control and Dante) over
two different network
cables
• Two different IP addresses
• One managed network
switch or two independent
network switches
f
Configure both Dante and
Control networks over two
different switches
f
Use two different IPs to address
the Control network and the
Dante network separately
f
Control the Dante network and the
Control network over different
ports of the TC Bar
X
For details see
„Split
Mode“