v1.0 | 7/21
Network Guide
TeamConnect Bar
3.4. Single Domain Mode
This mode is usually used if you want to use both the controller (Sennheiser or third-party provider)
and Dante on the same physical port with only one available IP in the same network.
To set up both configurations, you need the Sennheiser Control Cockpit for the control network and
the Dante Controller for other routed Sennheiser devices.
TC Bar S
• The TC Bar S has only one network port and can only provide a merged flow for Dante® and con-
trol over a switch.
To Next Page
Loading...
