Operation
26
The status LEDs remain green once the transmitter and receiver are
connected. If the status LEDs do not remain green, either the charge
level is below 15% (see „Checking the charge level during use“) or the
transmitter and receiver are not paired (see „Pairing“).
Switching off the transmitter and receiver
►
▷ Press the button on the transmitter and the button on the receiver until
the status LEDs switch off.
Muting the audio signal
When using a set, you can mute the audio signal. The audio signal can then
be unmuted.
►
▷ To mute the audio signal: Briefly press the button on the transmitter or
receiver.
►
▷ To unmute the audio signal: Briefly press the button on the transmitter
or receiver.
To Next Page
Loading...
