To Next PageTo Next Page
Need help?Do you have a question about the SENSIRION SCD30 and is the answer not in the manual?
General| Brand | SENSIRION |
|---|---|
| Model | SCD30 |
| Category | Accessories |
| Language | English |
Details the I2C communication protocol, speed, and clock stretching.
Describes the Modbus protocol, baud rate, and function codes for the sensor.
Lists all available commands for controlling and configuring the sensor.
Command to start continuous measurement with optional pressure compensation.
Command to stop continuous measurement of the SCD30.
Sets the interval for continuous measurement mode.
Checks if measurement data is available in the sensor's buffer.
Activates or deactivates continuous automatic self-calibration.
Sets temperature offset for compensation of thermal self-heating.
Compensates for CO2 measurement deviations due to altitude.
Command to retrieve the firmware version of the SCD30 module.
Resets the sensor to its state after power-up without removing power.
Explains conversion of digital sensor readings to physical units.
Safety warnings regarding product usage and potential injury.
Guidelines to prevent damage from electrostatic discharge.
Details the product warranty terms and conditions.
