Need help?Do you have a question about the Sensonix PE-8E and is the answer not in the manual?
Measuring Range and Repeatability| pH measuring range | 0 ～ 14 |
|---|---|
| pH resolving power | 0.01 pH |
| ORP measuring range | ± 1400 mV |
| ORP resolving power | 1 mV |
| pH repeatability | ± 0.05 |
| ORP repeatability | ± 5 mV |
Transmission Output| Transmission output | DC 4 ～ 20 mA |
|---|---|
| Maximum load resistance | 500 Ω |
| Linearity | 0.5 % |
Control Functions| Contact output | 1C Contact Output |
|---|---|
| Capacity | AC250V, 3A max |
| Control action | ON-OFF action |
Temperature Compensation| Temperature compensation elements | 6.8k Ω(25℃) or 500Ω(25℃) |
|---|---|
| Temperature compensation range | 0 ～ 100 ℃ |
| Ambient temperature | 5 ～ 40 ℃ |
Power and Dimensions| Power source | AC90 ～ 260 ℃ 50 / 60Hz 10W |
|---|---|
| Outline dimensions | 96 (W)× 96 H( )× 145 D( ) |
| Weight | 650 g |
Recommends suitable locations for meter installation based on environmental conditions.
Details the panel mounting procedure for the meter, including panel cut dimensions.
Explains how to configure internal switches (DIG and DIP) for various measurement settings.
Guides on connecting alarm contact outputs for ALM1 and ALM2, including capacity and load.
Details how to connect pH/ORP electrodes and temperature compensation electrodes to the meter.
Explains how to connect the transmission output cable for data transmission to receivers.
Describes the function of each key on the front panel of the PE-8E meter.
Explains the meaning and behavior of the indicator lamps (MEAS, CAL, DISP, ALM) on the meter.
Outlines the initial checks and procedures before starting meter operation and measurement.
Details the automatic and manual calibration procedures for the pH measurement function.
Describes the sensitivity check procedure for the ORP electrode using standard materials.
Explains how to display and set parameters like ALM values, measured value, and transmission output.
Guides on how to renew or adjust set values for parameters on the display.
Lists and explains various error codes that may appear on the meter display.
Provides solutions and actions to take for specific error codes displayed by the meter.
To Next Page