Sensonix PE-8E - Confirmation of the Setting Contents

-6-
2.3.3 Confirmation of the setting contents
This PE-8E displays main parameters of DIG.Switch and DIP.Switch when powered ON, and
then enters into measuring. Please check the displays when you re-set the contents after powerd
ON.
()()( )()Powered ON First Step Second Step measuring›› ›
PH Meter
Ω0-14pH 6.8 k
Measuring⇒⇒
ALM1:Hi ALM2:Lo
ORP Meter
When used as ORP Meter, display style differs depending on each range as follows;
±1000mV
Measuring⇒⇒
0~1000mV
Measuring⇒⇒
−1000〜0mV
Measuring⇒⇒
Each first display of each range is shown as follows;
±700mV
−700mV〜0ｍＶ
0 700mV〜
±350mV