Sensus OMNI R2 - Measuring Chamber; Tools Required

13
Measuring Chamber 4
This section describes how to remove the measuring chamber and how to
disassemble the measuring chamber when required to do so.
Tools Required
• 2.5, 3, and 6mm hex head ball end drivers (6mm not needed for the R2)
• Sensus seal screw tool—for bonnet removal
• Open end/box wrenches as determined by size and type of OMNI meter
• 7/16”x1/2” open end/box wrench
• 9/16” x 5/8” open end/box wrench
• 3/4” x 11/16” open end/box wrench
• 15/16” open end/ box wrench
• Assembly grease
CAUTION: If the meter is under pressure, pressure must be turned off
and relieved before chamber bolts are loosened or removed!