How to use
*Passive mode available: if you press the button while breath sampling, device will show
P (It means PASS) or F (It means FAIL) according to pre-set limit 0.02 % BAC
Recall memorized values on a menu mode
(*refer to back side of this manual)
●
last 10 test results with time record
●
3 types of test counting
:Since calibration / Alcohol positive / Device total
●
number of days & counting remaining until
a next calibration
Breathalyzer, Mouthpieces(x5), AAA Batteries(x2), Zipper case and User’s manual
Contents
1. Press power button 2 seconds then battery level will show as
Full Middle Low
2. Wait until you can see “0” sign.(Warming-up is going on)
3. When “0” appeared on the display,
blowing through the mouthpiece into the unit for
4 seconds until hearing click-crack sound.
4. The result is displayed for 10 seconds and turn off automatically
*if you want to test continuously, press the power button once while result is displaying
%BAC %BAC %BAC %BAC
To Next Page
Loading...
