Rev A Doc 6001573 Page 13 of 15
6 - REMOTE PROGRAMMING
To program the Spectrum system via telephone from a remote location, please refer to the following
instructions:
REMOTE PROGRAMMING FROM A TONE TELEPHONE
1. Dial the unit telephone number and wait for an answer. When the unit answers, it
emits two beeps.
2. Enter one asterisk “∗“ and the six-digit password. The unit will begin emitting a
high-pitched tone. Press the “#” key to stop the tone.
3. Once you are in the programming mode, a “b” appears on the unit’s display and two
short tones are emitted to signal that the unit is ready to be programmed.
4. Begin programming exactly the same as you would using the keypad on the unit.
NOTE The only functions that will not work from a remote location are the verify
functions and the ability to set the system’s feedback.
REMOTE PROGRAMMING VIA MODEM
The –101/–301 board has a modem and can be programmed remotely using this modem and SVWin
software. Please refer to the SVWin User’s Guide for programming instructions.
To Next Page
