Sentex SPECTRUM Series - Setting System Characteristics; Setting the Programming Password (STEP 01); Verifying the Programming Password (STEP 02); Setting the Dialing Type (STEP 03)

Rev A Doc 6001573 Page 5 of 15
4 - SETTING SYSTEM CHARACTERISTICS
The programming sequences described in this section allow you to set up the characteristics of your
telephone entry system. In general, you should only need to program your system during installation, not on
an on-going basis. Make sure you are in the programming mode before you start programming.
SETTING THE PROGRAMMING PASSWORD (STEP 01)
Purpose To change the code used to enter the programming mode.
Factory
Setting 000000.
Format 01 + programming password (6 digits) + #.
Example 01 + 123456 + # (sets the programming password to 123456).
Note: Be sure to change your code to one that only you know and is easy to
remember.
VERIFYING THE PROGRAMMING PASSWORD (STEP 02)
Purpose To verify the programming password.
Format 02 + programming password (6 digits) + #.
Note Once you press the “#” key, the system will either display a “1” or a “0”. If
the system responds with a “1”, the programming password you entered
matches the password in the system’s memory. If the system responds
with a “0”, the programming password is incorrect and you need to repeat
step 01 before exiting the programming mode
.
SETTING THE DIALING TYPE (STEP 03)
Purpose To set the dialing type to tones or pulses in order to enable/disable the
shared phone feature and display options such as tone/pulse and
shared phone.
Format 03 + type of dialing (one digit) + #
03 + # (1 is displayed for tone dialing, 0 is displayed for pulse dialing)
Example 03 + 1 + # (sets the dialing type to tones)
03 + 0 + # (sets the dialing type to pulses)
03 + # (displays whether dialing type is set to tones or pulses.
Note The factory default is ‘1’ for tone dialing.