Page 6 of 15 Doc 6001573 Rev A
VERIFY THE DIALING TYPE (STEP 03)
Purpose To verify that the dialing type is either a tone or a pulse
Factory setting = ‘1’
Format 03 + #
Note Once you press the “#” key, the display will show that the dialing type is
either 1 for tone or 0 for pulse.
SETTING RINGS BEFORE ANSWER (STEP 04)
Purpose To set the number of times the phone will ring before the system answers
it. The number of rings can be from 0 to 9. Factory setting = 2
Format 04 + n + # number of rings (0 <=n <=9) + #.
Example 04 + 4 + # (sets the number of rings to 4).
VERIFY RINGS BEFORE ANSWER (STEP 04)
Purpose To verify the number of times the phone will ring before the system
answers it. The number of rings can be from 0 to 9. Factory setting = 2
Format 04 + #
Note Once you press the “#” key, the display will show the number of times the
phone will ring before the system answers it.
SETTING THE VISITOR TALK TIME (STEP 05)
Purpose To set the maximum length of a call that can be made by a visitor. This
length can be set from 15 to 255 seconds.
Factory setting = 60 seconds.
Format 05 + number of seconds (up to 3 digits) + #.
Example 05 + 45 + # (sets the talk time to 45 seconds).
VERIFYING THE VISITOR TALK TIME (STEP 05)
Purpose To verify the maximum amount of time a visitor can stay on a visitor call.
Format 05 + #.
Note Once you press the “#” key, the display will show the maximum number
of seconds allowed for a visitor call.
To Next Page
Loading...