7
Troubleshooting
Troubleshooting
Problems Causes Solutions
Tool shaft does not
rotate after starting
the machine
Loose electric wiring
Check electric wiring, plug
and cord
Oil leakage The seal rings are worn out
Replace seal rings
Motor temperature
raised while reduced
output speed
Too low voltage Check the power supply
Overloaded Reduce load
The speed of mixing is too
high or you may be using
the wrong attachment.
Select a suitable speed and
attachment
The attachments hit
the bowl
The attachment or bowl
may be damaged
Repair or replace the
attachment or bowl
Noise or high
temperature from
gearbox
Insufficient lubrication Add or replace the grease
To Next Page
Loading...
Need help?
General
