SENTRY II 950SM Series - Setting Time of Day and Operating Screens

15
Screen 3
Step 1
Control Valve Programming
Normal Operating Screens
Screen 1
Screen 2
Step 1 - Press SET CLOCK
Step 2 - Current Time of Day - Hours: Adjust to the correct hour by pressing the UP or
DOWN arrow button. Press NEXT to go to Step 3.
Step 3 - Current Time of Day - Minutes: Adjust to the correct minutes by pressing the up or
down arrow button. Press NEXT to return to the normal operating screen.
The time of day should only need to be set after initial installation or after an extended power outage. If an
extended power outage has occurred, the time of day will flash indicating that it needs to be set.
Set the Time of Day
Step 2
Step 3
During normal operation one of three screens can be displayed.
Pressing the NEXT button alternates between these screens.
Screen 1 - Current Time of Day
Screen 2 - Current Flow Rate in Gallons per Minute
Screen 3 - Capacity Remaining in Gallons