Need help?Do you have a question about the SENTRY II 960 Series and is the answer not in the manual?
General| Brand | SENTRY II |
|---|---|
| Model | 960 Series |
| Category | Water Dispenser |
| Language | English |
Details water pressure, temperature, electrical requirements, and meter specifications.
Lists precautions regarding lubricants, hydrocarbons, water meter usage, and pipe dope.
Lists requirements before installing the softener, including power, drainage, and pressure reducing valve.
Covers floor space, leveling, bypass consideration, and connection kit components.
Details steps for preparing the bypass assembly connection kit.
Instructions on connecting the water softener to existing plumbing, noting flow direction and bypass valve position.
Guides on drain line connection, specifications, and air gap requirements.
Guides on connecting the overflow line to drain and the brine line to the brine fitting.
Step-by-step guide to initiate the start-up process, including placing the bypass and cycling the softener.
Critical note about checking for leaks after the brine tank fills.
Explains how the control valve is pre-programmed and how to adjust water hardness.
Guides on adjusting the raw water hardness setting.
Instructions for setting the current time of day on the control valve.
Describes the screens displayed during normal operation and how to switch between them.
Lists parts for the front cover and drive assembly with drawing numbers and quantities.
Details internal parts of the main body, including pistons and O-rings.
Lists parts for the injector housing, including the injector cap and screen.
Lists parts of the water meter assembly, including the turbine and plug.
Details components of the brine elbow refill flow assembly and port plug.
Lists parts for the drain line assembly, including elbow and flow control components.
Lists parts for the 1" drain assembly, including fittings and DLFC options.
Details components of the bypass assembly, including nuts, rings, rotor, and caps.
Illustrates the different operational modes of the bypass valve.
Lists parts for PVC male NPT elbow and solvent 90° elbow assemblies.
Lists parts for 1" and 3/4" Brass Sweat installation fittings.
Details components of the brine tank assembly, including deck, tank, and brine valve.
Table showing grain capacity, mineral tank size, gravel, resin, and distributor assembly.
Table showing grain capacity, brine tank size, deck height, and brine valve details.
Table linking grain capacity to injector size, flow control GPM, and refill time.
Steps to remove and inspect the drive assembly, including gears and motor.
Instructions for reassembling the drive assembly, bracket, and motor.
Explains how to remove and access the drive cap assembly and its parts.
Steps for disassembling and reassembling the main and brine pistons.
Steps for removing and reassembling the seal and spacer stack assembly.
How to disassemble and reassemble the injector cap, screen, and injector.
Guides on removing and reassembling the refill flow control assembly.
Troubleshooting display, time, and regeneration errors related to the circuit board.
Troubleshooting hard water, excessive salt, residual salt, and brine tank water issues.
Troubleshooting errors related to drawing brine, water running to drain, and motor movement.
Troubleshooting motor errors 1003 and 1004 related to timing and position.
To Next Page
