SENTRY II 960 Series - Setting the Time of Day; Normal Operating Screens

15
5:20
2890
Screen 2
Control Valve Programming
Set the Time of Day
NEXT
REGEN
Step 1
SET
CLOCK
NEXT
REGEN
SET TIME
4:35
Step 2
NEXT
REGEN
SET TIME
5:20
Step 3
Exit
Programming
Mode
SET
CLOCK
During normal operation one of three screens can be displayed.
Pressing the NEXT button alternates between these screens.
Normal Operating Screens
Screen 1 - Current Time of Day
Screen 2 - Capacity Remaining in Gallons
The time of day should only need to be set after initial installation or after an extended power
outage. If an extended power outage has occurred, the time of day will flash indicating that it needs
to be set.
Step 1 - Press SET CLOCK
Step 2 - Current Time of Day - Hours: Adjust to the correct hour by pressing the UP or DOWN
arrow button. Press NEXT to go to Step 3.
Step 3 - Current Time of Day - Minutes: Adjust to the correct minutes by pressing the up or down
arrow button. Press NEXT to return to the normal operating screen.
SET
CLOCK
NEXT REGEN
Screen 1
TIME
SET
CLOCK
NEXT
REGEN
CAPACITY REMAINING
GAL
SET
CLOCK