SENTRY II 960 Series User Manual

4
System Specifications
Water pressure: 40 psi minimum 100 psi Maximum
Water Temperature: 40°F to 110°F
Electrical Requirements:
Supply Voltage: 120V
Supply Frequency: 60Hz
Output Voltage: 12V AC
Output Current: Maximum 3.0 Amps
Water Meter:
Pipe Size: 1”
Accuracy: ± 5%
Minimum Flow : 0.25 GPM
Control Valve to Tank Connection: 2.5”-8UN
Control Valve Distributor Pipe Connection: 1.050”
Circuit Board Memory: NonVolatile EEPROM (Electrical Erasable Programmable Read Only Memory)
Compatible with the following typical concentrations of regenerant chemicals: Sodium Chloride, Potassium
Chloride, Potassium Permangenate, Sodium Bisulfite, Chlorine and Chloramines
Warnings
The control valve and fittings are not designed to support the weight of the system or the
plumbing.
Do not use Vaseline, oils, other hydrocarbon lubricants or spray silicone anywhere. A
silicone lubricant may be used on black O-rings.
Hydrocarbons such as kerosene, benzene, gasoline, etc., may damage products that
contain O-rings or plastic components. Exposure to such hydrocarbons may cause the
products to leak. Do not use the product(s) contained in this document on water supplies
that contain hydrocarbons such as kerosene, benzene, gasoline, etc.
The water meter should not be used as the primary monitoring device for critical or health
effect applications.
Do not use pipe dope or other sealants on threads. Teflon tape is recommended to be
used on all threads. Use of pipe dope may break down the plastics in the control valve.
System Specifications and Warnings

SENTRY II 960 Series Specifications

General

Brand	SENTRY II
Model	960 Series
Category	Water Dispenser
Language	English