SENTRY II 960SM Series - Time and Display Settings

7
2890
Screen 2
5:20
SET
CLOCK
NEXT
4:35
5:20
Step 1
SET
CLOCK
NEXT REGEN
Normal Operating Screens
Screen 1 - Current Time of Day
Screen 2 - Capacity Remaining in Gallons
SET
CLOCK
NEXT
REGEN
CAPACITY REMAINING
GAL
Screen 1
TIME
PM
Exit
Programming
Mode
SET
CLOCK
The time of day should only need to be set after initial installation or after an extended power outage. If an
extended power outage has occurred, the time of day will flash indicating that it needs to be set.
Step 1 - Press SET CLOCK
Step 2 - Current Time of Day - Hours: Adjust to the correct hour by pressing the UP or DOWN
arrow button. Press NEXT to go to Step 3.
Step 3 - Current Time of Day - Minutes: Adjust to the correct minutes by pressing the up or down
arrow button. Press NEXT to return to the normal operating screen.
During normal operation one of three screens can be displayed.
Pressing the NEXT button alternates between these screens.
SET
CLOCK
NEXT
NEXT
REGEN
REGEN
REGEN
Step 2
Step 3
SET TIME
SET TIME
PM
PM
Control Valve Programming
Set the Time of Day