What to do if the red indicator light is blinking on my SentrySafe SFW123ES Other?
If the red indicator light is blinking on your SentrySafe Other, it means that an incorrect code has been entered three times. To resolve this, wait two minutes and then start the process over.
How to open SentrySafe Other if it won't open after entering the code?
If you cannot open the door after entering the electronic code on your SentrySafe Other, it might be because safes doors equipped with a water-resistant gasket may initially be tight. Try holding the handle up while inputting the code, and then pull down when the green light comes on.
Why is the yellow indicator light on my SentrySafe Other?
If the yellow indicator light is on, it means the battery power is low, and the handle will not open. Replace the batteries to resolve this issue.
Why won't the door lock on my SentrySafe SFW123ES Other?
If the door of your SentrySafe Other will not lock, it might be because the shipping screw is still in place. Remove the screw on the back inside of the door.
What does it mean when the red light blinks three times on my SentrySafe SFW123ES?
If the red indicator light blinks three times and you hear three beeps on your SentrySafe Other, it signifies that an incorrect code has been entered. Verify the code and re-enter it.
Why is the handle on my SentrySafe SFW123ES not horizontal when locked?
If the handle is not in the horizontal position when your SentrySafe Other is locked, it means that the clutch mechanism has been engaged. Rotate the handle up or down until it clicks into the horizontal position.
What does it mean when the red light blinks once on my SentrySafe Other?
If the red indicator light blinks once and there is one beep on your SentrySafe Other, it indicates that the program button was pressed out of sequence, or 5 seconds have lapsed between button entries. Start over.
Product not intended for storage of firearms, combustible materials, or medication.
Instructions for installing batteries and preparing the electronic lock.
Steps to unlock the safe using the electronic keypad and handle.
Steps to lock the safe using the electronic keypad and handle.
Details on factory, user, and secondary codes for the electronic lock.
Instructions on how to add or delete a user code for the electronic lock.
Instructions on how to add or delete a secondary code for the electronic lock.
General| Brand | SentrySafe |
|---|---|
| Model | SFW123ES |
| Category | Other |
| Language | English |
To Next Page
