SentrySafe SFW123ES - Bolting Down Your Safe; Bolt Down Kit and Tools; Drilling for Bolt Down

11
English
Bolting Down Your Safe
Bolt down instructions
Bolt down kit contents (in select models only):
s LAGSCREWS
s WASHERS
s MASONRYANCHORS
Tools needed to bolt safe to the floor:
s $RILL
s 7RENCH
s
7
⁄
16
” (11 mm) drill bit – for drilling into the safe.
s
9
⁄
32
” (7.2 mm) drill bit – for drilling into a wood floor.
s
3
⁄
8
” (9.5 mm) drill bit – for drilling into a masonry floor.
7ARNING s$/./4DRILLTHROUGHBOLTCUPS
 s$/./4BOLTTHROUGHTHEWALLS
 s$O./4DRILLFROMANYLOCATIONINSIDETHESAFE
1
Tip the safe onto its left side (door hinges horizontal with the floor).
2
Unlock the safe and open the door. Look to the bottom of the
safe for two indentations on the feet in opposite corners. Using
the
7
⁄
16
” (11 mm) bit; drill a hole through each indentation
perpendicular to the bottom of the safe. Do NOT drill from
any location inside the safe.
3
Tip the safe upright, place the safe in the desired location and open the door.
4
Use a screw or pencil to mark the floor through both holes.
For products that do not come with a bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
Warning: Product is not water resistant once it is bolted down. The ETL verified water
resistance claim applies to product prior to the application of a bolt-down kit.