SeQual Eclipse 3 - User Manual

Questions and Answers

J
Joseph JohnsonJul 26, 2025
How to fix SeQual Eclipse 3 Oxygen Equipment Eclipse when it does not power on?
- A
  alexanderwilliamsJul 26, 2025
  If your SeQual Oxygen Equipment Eclipse doesn't power on, several factors could be at play. First, ensure a battery is installed or plug the device into external power. If a battery is already present, it might be discharged, so connecting to external power is recommended. Check that the AC or DC power supply is correctly plugged into the outlet, the power supply box, and the Eclipse itself. Also, verify that the outlet provides sufficient power, as it might be controlled by a wall switch or a tripped circuit breaker.
J
Joel GlennAug 3, 2025
What to do if my SeQual Eclipse 3 is not delivering oxygen?
- V
  Vincent ReevesAug 3, 2025
  If you're not getting any oxygen from your SeQual Oxygen Equipment, start by checking the air inlet filter and clean it if it's blocked. Inspect the humidifier attachment and tubing for any issues. Ensure that your Eclipse is powered on. Verify that the tubing and cannula are properly connected and not kinked, correcting any connection problems or obstructions.
M
michael50Aug 10, 2025
Why is my SeQual Eclipse 3 Oxygen Equipment showing low oxygen concentration or flow?
- S
  Sara FigueroaAug 11, 2025
  If you experience low oxygen concentration or flow with your SeQual Oxygen Equipment, there are several things to check. First, inspect the tubing or humidifier for any restrictions and repair or replace them as needed. Ensure your Eclipse has adequate airflow around it. Also, check the air inlet filter and clean or replace it if it's blocked. Again, make sure that there is adequate airflow. If you're using Pulse Mode and exceeding the maximum breath rate, switch to Continuous Flow Mode until your respiratory rate returns to normal.
J
Julie JohnsonAug 17, 2025
What to do if SeQual Eclipse 3 delivers no oxygen in Pulse Flow Mode?
- S
  Sandra WarrenAug 17, 2025
  If your SeQual Oxygen Equipment is not delivering oxygen in pulse flow mode, ensure that the tubing/cannula is no longer than 7 feet (2.1m). If a humidifier is attached, remove it. Make sure the unit is set to Pulse Mode and not Continuous Mode. Check that the nasal cannula is properly placed in your nostrils, and that you are breathing through your nose.

Summary

Important Safety Instructions

Symbols and Warnings Explained

Explains device symbols, warnings, and cautions for safe operation.

Safety Guidelines

General Safety Precautions

Key safety precautions for operating the Eclipse device and its components.

Power Cartridge (Battery) Safety

Recommended Operating Environments

Operating Instructions

Powering and Charging the Device

Instructions on connecting power sources (AC/DC) and initial battery charging procedures.

Rechargeable Power Cartridge (Battery)

Battery Installation and Operation

Information on installing, charging, and operating the rechargeable power cartridge (battery).

Initial Battery Charging

Operating Your Eclipse for the First Time

Positioning, Powering On, and Flow Mode Selection

Steps for positioning, powering on, and selecting flow modes for initial use.

Pulse Dose Mode and autoSAT Features

Adjusting Flow Setting to Prescribed Level

Troubleshooting Common Issues

SeQual Eclipse 3 Specifications

General

Operating Temperature	50°F to 104°F (10°C to 40°C)
Oxygen Output	0.5 to 3 LPM (continuous flow)
Oxygen Concentration/Purity	90% ± 3%
Operating Modes	Continuous flow
Noise Level	45 dBA
Power	AC/DC power supply

Related product manuals

SeQual Eclipse 1000

52 pages