Sequential OB-6 - Sequencer Transposition in Unison Mode

3
To control an external MIDI device:
1. Connect the MIDI or USB output of the OB-6 to the MIDI or USB input
of the external device, depending on which type of connection the external
device requires.
2. On the OB-6, press the  button, then press program selector button 9
(midi out) to select nid (midi) or usb (usb).
3. Press the  button again to exit the Global menu.
4. On the external device, set the MIDI Channel and MIDI Receive port to
match the OB-6.
5. Hold down a chord on the OB-6 or start sequencer playback. e external
device should be triggered by the arpeggiated or sequenced notes.
Transposing Sequencer Playback
As you know, when working with sequences, you can transpose the key of a
sequence during playback by holding down the  button and pressing a key
on the OB-6 keyboard (or external keyboard controller if you’re using the OB-6
module).
With OS 1.5.5, if you’re using a program with Unison enabled, you don’t need to
hold down the  button. You can simply press a note on the keyboard and the
sequence is transposed to that key. (When not using Unison, you must still hold
down the  button to enable transposition.)
Remember that “Middle C” is the reference point. Playing a note above middle
C transposes the sequence higher by that interval. Playing a note below middle C
transposes the sequence lower by that interval.