Need help?Do you have a question about the Sequential Prophet Rev 2 and is the answer not in the manual?
General| Brand | Sequential |
|---|---|
| Model | Prophet Rev 2 |
| Category | Synthesizer |
| Language | English |
Covers sound bank organization, program selection, editing, saving, and naming.
Explains bi-timbral operation, layering sounds, and splitting the keyboard.
Points to further sections for advanced sound design and integration.
Describes power, USB, MIDI, Sequencer, Sustain, Pedal/CV, Audio, and Headphone jacks.
Covers master tune, MIDI channels, clock modes, parameter transmission, and control enables.
Explains screen saver, pedal modes, sustain ARP, calibration, and program/bank dumping.
Details frequency, waveshape, sync, sub-oscillator, noise, and slop parameters.
Covers cutoff, resonance, envelope amount, velocity, key amount, and audio modulation.
Explains delay, attack, decay, sustain, and release parameters for filter envelope shaping.
Details delay, attack, decay, sustain, release, pan spread, and velocity modulation for volume.
Details LFO waveshapes, frequency, clock sync, destination, amount, and key sync.
Lists available modulation sources, destinations, and the concept of routing.
Provides step-by-step guides for creating vibrato and controlling filter cutoff.
Lists available effects (delay, chorus, phaser, etc.) and how to apply and adjust them.
Covers arpeggiator usage, beat sync, modes, range, repeats, and tempo.
Details momentary sustain modes, MIDI output, and parameter settings.
Explains programming, playing, transposing, and copying sequences.
Details gated sequencer programming, destinations, and the use of slew for smooth transitions.
Covers sequencer type, play/record modes, destination, track, mode, and clock parameters.
Covers selecting unison voices, detuning, and storing/recalling chords.
Discusses note priority settings and their impact on unison mode.
Explains master volume and setting individual program volumes.
Explains how to use glide and select different glide behaviors.
Setting the semitone range for the pitch wheel.
Using the mod wheel for real-time parameter modulation and applying pressure for dynamic changes.
Covers oscillator reset, key modes, pan modes, glide modes, and unison settings.
Steps for exporting programs, banks, or all banks using SysEx.
Procedures for importing programs and banks using SysEx librarian software.
Steps to recalibrate the synth's core components and performance controls.
Explains USB setup, driver requirements, and MIDI data transmission.
Comprehensive list of all sources for modulating synthesizer parameters.
Provides detailed descriptions for various tuning systems like Harmonic Series and Pythagorean.
Offers solutions for no sound, sequencer/arpeggiator stops, sound differences, and ground hum.
Contact details for technical assistance, warranty information, and repair procedures.
Explains MIDI channels, clock modes, parameter transmission, and SysEx cables.
Lists system real-time, channel, controller, and SysEx messages.
Lists CC and NRPN numbers and their corresponding parameters on the Rev2.
Comprehensive table listing all program parameters mapped to NRPN numbers.
Lists control NRPN data and SysEx message structures for device inquiry and Rev2 data.
Explains SysEx messages for requesting and sending program, edit buffer, and global parameter data.
Describes how data is packed into MIDI bytes for transmission.
To Next Page
