42
43Arpeggiator
Sequential Prophet Rev2 User’s Guide
Arpeggiator
Arpeggiator “Momentary Sustain” Mode
The Rev2 allows you to use the sustain pedal to turn the arpeggiator’s
Hold function on and off and perform other arpeggiator-related functions.
To access this feature, use the sustain arp setting in the global menu.
ere are three modes to choose from:
• - With the arpeggiator running in this mode, pressing the
Sustain pedal once causes the arpeggiator to hold the sequence (even
when you release the notes on the keyboard). Pressing it again stops the
arpeggiator.
• - With the arpeggiator running in this mode, pressing and
holding the Sustain pedal sustains the notes, as the Sustain pedal
normally would.
• - With the arpeggiator running in this mode, pressing
and holding the Sustain pedal causes the arpeggiator to sustain (even
when you release the notes on the keyboard) for as long as you hold
down the pedal. Releasing the Sustain pedal stops the arpeggiator.
To select the arpeggiator’s sustain pedal mode:
1. Press the button then use knob to select
.
2. Turn the knob to select either , , or
, depending on your preference. Press the button again to
exit the Global menu.
MIDI Note Output from the Arpeggiator and Sequencer
e Rev2’s arpeggiator and sequencer output MIDI note numbers. Any
notes that you hold on the Rev2 keyboard will be arpeggiated accord-
ing to the current settings of the arpeggiator and output over MIDI as
MIDI notes. Similarly, any notes output by the sequencer will be output
over MIDI as MIDI notes. You can use this feature to drive other MIDI-
equipped devices such as synthesizers and drum machines. To access this
feature, use the + setting in the menu.
To enable MIDI Note output from the arpeggiator:
1. Press the button, then turn the knob to select
+.
2. Turn the knob to select .
To control an external MIDI device:
1. Connect the MIDI or USB output of the Rev2 to the MIDI or USB input
of the external device, depending on which type of connection the
external device requires.
2. On the Rev2, press the button, then use the knob
to select .
3. Use the knob to select , or , or +, depending on
how your Rev2 and external device are connected.
4. Press the button again to exit the Global menu.
5. On the external device, set the the MIDI Channel and MIDI Receive
port to match the Rev2.
6. Hold down a chord on the Rev2 or start sequencer playback. e exter-
nal device should be triggered by the arpeggiated or sequenced notes.
Arpeggiator Parameters
On/Off—This button turns the arpeggiator on and off.
Mode: Pressing this button shows various arpeggiator options in the
OLED display. You can scroll through these and choose their settings
with the parameter and value knobs.
Arp Mode: Sets the order in which notes play when the arpeggiator is on. See
the table.
Arp Mode Behavior
Up Plays from lowest to highest note
Down Plays from highest to lowest note
Up + Down Plays from lowest to highest and back to lowest
Random Plays notes in random order
Assign Plays notes in the order the keys were pressed
To Next Page
Loading...
