Need help?Do you have a question about the Sequential TAKE 5 and is the answer not in the manual?
General| Type | Analog Synthesizer |
|---|---|
| Polyphony | 5 voices |
| Oscillators | 2 VCOs per voice |
| Arpeggiator | Yes |
| Modulation | Extensive modulation matrix |
| Waveforms | Sawtooth, Triangle, Pulse |
| Filter | 4-pole, resonant, low-pass filter |
| Envelopes | 2 ADSR envelopes (filter and amplifier) |
| Effects | Reverb, Delay, Chorus |
| Sequencer | 64-step polyphonic sequencer |
| Outputs | 2 x 1/4" (main out), 1 x 1/4" (headphones) |
| MIDI | MIDI In, MIDI Out, MIDI Thru |
Details the connectors for power, USB, MIDI, audio, and pedals on the rear panel.
Step-by-step guide to connect and power on the Take 5 synthesizer.
Instructions for running the built-in oscillator and filter calibration procedure.
Details parameters that affect all programs, like MIDI channel and curves.
Explanation of the two analog, voltage-controlled oscillators and sub-oscillator.
Describes the function of the filter in shaping the sound's harmonic content.
Details the two 5-stage envelope generators for creating modulation.
Explains the process of routing parameters to create unique sounds.
Details the digital effects available, including delay, chorus, and reverb.
Tutorial on creating a classic synth bass sound using basic components.
Common scenarios and solutions for problems or unexpected behavior.
Instructions to reset global parameters to their factory default settings.
Information on how to contact technical support for assistance.
Details on warranty coverage and the process for repair service.
To Next Page
