4 Setting Up the Take 5
Sequential
Tune the Oscillators and Filters
The rst time you use the Take 5, run its built-in oscillator and lter cali-
bration procedure. Repeat the calibration procedure if needed over the
next few days. The Take 5 learns the range of temperatures and will keep
itself in tune over this range.
To calibrate the oscillators and lters:
1. Press the settings button.
2. With the knob, choose the command.
3. Press the button.
4. e Take 5 performs its auto-calibration procedure. Don’t turn o the
power while it’s doing this.
5. When nished, the front panel controls return to normal and you can play
the Take 5.
Listen to the Factory Sounds
e Take 5 contains 256 programs. ese are divided into two sets of 128
programs — a Factory set and a User set.
• When the factory button is lit, the 128 permanent Factory programs
are active. These cannot be overwritten.
• When the factory button is not lit, the 128 User programs are active.
you can freely edit and resave these. As shipped from the factory, the
Factory and User presets are identical.
Most factory programs have a sequence associated with them. A quick and
easy way to audition programs is to press the Sequencer’s button to hear
its associated sequence.
The Bank and Program Select controls
To Next Page
Loading...
