Sequential TAKE 5 - Setting Up the Take 5

3
Take 5 User’s Guide
Setting Up the Take 5
8. Audio Outputs—Unbalanced, ¼ inch audio outputs. The Take 5
sounds great in stereo, but can be switched to mono if needed. See
“Global Settings” on page 10.
9. Headphones — ¼ inch stereo headphone jack. Headphone volume is
controlled by the master volume knob on the front panel.
Setting Up the Take 5
Here’s how to get your Take 5 up and running:
1. Plug the power cable into the power connector on the back of the Take 5.
2. If you have an expression pedal, connect it to the pedal jack on the
back of the Take 5. You can use it to control volume, lter cutoff, and
other aspects of a sound. If you have a sustain pedal, connect it to the
ftswitch jack on the back of the Take 5.
3. Turn on the Take 5.
4. Connect the left and right audio out connectors on the back of the
Take 5 to your amp/mixer/powered speakers using unbalanced, ¼ inch
audio cables.
5. Turn up the volume on your amp/mixer/powered speakers.
6. Turn up the volume on the Take 5.
4
1 2 3
6 7 8 95