Sequential TAKE 5 - MIDI Note Output from the Arpeggiator

46 Arpeggiator Sequential
MIDI Note Output from the Arpeggiator
e Arpeggiator outputs MIDI note messages. Any notes that you hold
on the keyboard will be arpeggiated according to the current settings of
the Arpeggiator and output over MIDI as MIDI notes. You can use this
feature to drive other MIDI-equipped devices such as synthesizers and
drum machines. To access this feature, use the    setting in
the  menu.
To enable MIDI Note output from the Arpeggiator:
1. Press the  button, then use the  knob to locate the 
  parameter.
2. Use the  knob to select .
To control an external MIDI device:
1. Connect the MIDI or USB output of the Take 5 to the MIDI or USB
input of the external device, depending on which type of connection
the external device requires.
2. On the Take 5, press the  button, then use the  knob to
locate the midi cable out parameter.
3. Use the  knob to select , , or , depending on how your
Take 5 and external device are connected.
4. Press the  button again to exit the Global menu.
5. On the external device, set the the MIDI Channel and MIDI Receive
port to match the Take 5.
6. Hold down a chord on the Take 5 or start Sequencer playback. e
external device should be triggered by the arpeggiated or sequenced
notes.