75
Take 5 User’s Guide
Appendix D: Calibrating the Take 5
Appendix D:
Calibrating the Take 5
Because the Take 5 is calibrated at the factory, controls such as the Pitch
and Mod wheels, Touch Slider, and analog lters shouldn’t require
re-calibration. But if you experience unexpected behavior with these
controls, you can use the calibration function to tune them occasionally.
Calibrating the VCOs and Filters
To calibrate the VCOs and lters:
1. Press the global button.
2. Use the
select knob to select cal voices, then press write.
3. The synthesizer performs its auto-calibration procedure. Don’t turn off
the power while it’s doing this.
4. When nished, the front panel controls will return to normal and you
can play the Take 5 again.
Calibrating the Pitch and Mod Wheels
To calibrate the Pitch and Mod wheels:
1. Press the global button.
2. Use the
select knob to select cal wheels, then follow the instructions in
the display.
3. When nished, press the
global button again to exit the global menu.
You can now can play the Take 5 again.
Resetting the Global Parameters
If you’re trying to track down a problem, it’s sometimes a good idea to
reset the Global parameters to their defaults. This is a quick way to make
sure that the Take 5 returns to its factory settings.
To reset all Global parameters to their default settings:
1. Press the global button.
2. Use the select knob to select reset globals, then press write. Globals are
reset. You can now can play the Take 5 again.
To Next Page
Loading...
