58
59Pan Spread
Sequential Prophet Rev2 User’s Guide
Hold
Pan Spread
Pan Spread, in the Amplier section, pans audio in the stereo eld indi-
vidually per voice. Set to 0, all voices are panned to the center. As you
turn the pan spread knob clockwise, each voice is gradually moved away
from the center by greater amounts. Every other voice goes in a different
direction, left or right. This creates a broader stereo eld while playing.
AMPLIFIER
PAN SPREAD
ATTACK
ENV AMOUNT
DECAY
VELOCITY
SUSTAIN
DELAY
RELEASE
Pans individual voices
in the stereo field
Pan Spread
Transpose
The up and down buttons in the transpose section transpose the keyboard
up or down in octaves. The LED indicates the current keyboard trans-
position state. Transposing the keyboard also changes the MIDI note
numbers of the keys so that MIDI notes sent are also transposed. Trans-
pose settings are global and are not saved with individual programs.
TRANSPOSE
Down
Up
The Transpose controls
Hold
When hold is on, any notes played will continue to play until hold is
turned off. When used in conjunction with the arpeggiator, notes are
latched on. If hold is on and at least one key continuously held down,
any new notes played are added to the arpeggio.
HOLD
The Hold button
Glide
Glide causes the pitch of a note to glide up or down from the pitch of the
previously played note. Glide is turned on and off using the glide switch,
but the rate must also be set. If the glide button is on, but rate is set to
0, glide has no effect.
RATE
GLIDE
The Glide controls
To use glide:
1. Press the glide button.
2. Play a series of notes up and down the keyboard while you turn the
rate knob to adjust the amount of glide.
To set the glide amount separately for each oscillator:
1. Press the glide button.
2. Press the misc params button and use the parameter knob to scroll to
osc 1 glide.
3. Turn the value knob to set the mode and play a series of notes up and
down the keyboard to hear the effect.
To Next Page
Loading...
