Why does foam formation break down in Sera Marin Precision Biotop LED Cube 130?
If your Sera Aquarium's foam formation breaks down, it might be due to feeding fatty foods like fish or mussels. If this is the case, foam formation should begin again after a few hours. Another possible cause is a congested air intake. Try cleaning the air intake or opening it further.
What to do if the foam is too dry in Sera Aquariums?
If the foam in your Sera Aquarium is too dry or very viscous, the water level within the unit may be too low, so immerse the skimmer deeper. Another possibility is insufficient pump performance; in this case, clean the rotor, shaft, and intake nozzle.
Why is there too much foam in my Sera Aquarium?
If the foam in your Sera Aquarium is too moist or there's too much foam, it could be because the water level within the unit is too high. To resolve this, place the skimmer in a higher position.
Why is foam formation too strong in my Sera Aquarium?
If you observe foam formation that is too strong, very brownish flotate, and very sticky foam in your Sera Aquarium, it indicates that the water is strongly polluted. Perform a partial water change and reduce the amount of food you are feeding your fish.
How to increase foam formation in Sera Aquariums?
If you have insufficient foam formation in your Sera Aquarium, it is likely due to an insufficient amount of air. Open the intake valve further to increase air intake.
What to do if the control LED is not on in my Sera Aquarium?
If the control LED on your Sera Aquarium is not on, the issue might be due to a lack of electrical supply. First, check the plug to ensure it is properly connected. If that's not the problem, make sure the transformer is plugged in.
How to fix insufficient air intake rate in Sera Aquariums?
If you're experiencing insufficient air intake rate in your Sera Aquarium, there are several potential causes. The intake valve might not be opened sufficiently, so try opening it further. The air hose could be encrusted with lime or dirt, requiring cleaning. The intake nozzle on the pump might also be dirty, so clean that as well. Finally, the pump performance could be too low, in which case you should clean the rotor and shaft.
What to do if the UV-C lamp is not on in my Sera Aquarium?
If the UV-C lamp in your Sera Aquarium is not turning on, start by checking all cable connections to ensure they are properly connected. If the connections are secure, the UV-C lamp itself may be faulty and need replacement. Also, make sure that the blue and black plugs are connected correctly.
Why are cloudiness/algae unaffected in my Sera Aquarium?
If you're experiencing cloudiness or algae that remain unaffected in your Sera Aquarium, and it's due to mineral cloudiness rather than a bacterial cause, use a fine particle filter and perform a water change. If the UV-C lamp is faulty or too old, replace the lamp unit.
To Next Page
General
