What to do if foam formation is too strong in my Sera PS 200 Aquariums?
If the foam formation in your Sera aquarium is too strong, resulting in very brownish flotate and sticky foam, it indicates that the water is heavily polluted. Perform a partial water change and reduce the amount of food you are feeding your fish. Also, increase flotate moisture.
Why is there too much foam in my Sera PS 200 Aquariums?
If the foam is too moist or there is too much foam in your Sera aquarium, this is because the water level within the unit is too high. Place the skimmer in a higher position.
How to fix insufficient foam formation in Sera PS 200 Aquariums?
If there is insufficient foam formation in your Sera aquarium, it is caused by an insufficient amount of air. Open the intake valve further.
How to increase air intake in Sera PS 200 Aquariums?
If your Sera aquarium has an insufficient air intake rate, it could be due to several reasons. The intake valve may not be opened sufficiently – try opening it further. The air hose might be encrusted with lime or dirt, in which case you should clean it. Also, the intake nozzle on the pump could be dirty, so clean that as well. Finally, the pump performance might be too low, requiring you to clean the rotor and shaft.
Why does foam formation break down in Sera Aquariums?
If the foam formation in your Sera aquarium breaks down, it could be due to feeding fatty foods like fish or mussels; in this case, foam formation will begin again after a few hours. Alternatively, the air intake might be congested, so clean the air intake or open it further.
What to do if foam is too dry in Sera PS 200 Aquariums?
If the foam in your Sera aquarium is too dry or very viscous, it may be caused by a water level within the unit that is too low, so immerse the skimmer deeper. Another possible cause is insufficient pump performance, so clean the rotor, shaft, and intake nozzle.
Describes the protein skimmer's purpose, capacity, and suitability for different aquariums.
Lists the items provided with the sera marin Protein Skimmer PS 200.
Explains the essential role of protein skimmers in maintaining marine aquarium water quality.
Details the mechanism by which the skimmer draws in air and water to remove waste.
Guides users through the process of installing the protein skimmer in an aquarium.
Outlines how to clean the flotate cup, pump, and internal components of the skimmer.
Addresses common operational issues like insufficient foam or poor air intake with solutions.
Lists essential safety precautions for operating the unit and handling electrical components.
Lists detailed specifications including dimensions, volume, power, and protection class.
Identifies replaceable components for the protein skimmer.
Explains the product warranty period, coverage, and exclusions.
Guides users on seeking support for defects and general product recommendations.
Provides instructions for the proper disposal of electrical and electronic waste.
To Next Page
General
