Why is foam formation too strong in my Sera aquarium?
Strong foam formation, very brownish flotate, and very sticky foam in your Sera aquarium often indicate that the water is heavily polluted. Perform a partial water change and reduce the amount of food you're feeding your fish.
What to do if the foam formation breaks down in my Sera aquarium?
If the foam formation in your Sera aquarium breaks down, it could be due to feeding fatty foods like fish or mussels. The foam formation should begin again after a few hours. Another possible cause is a congested air intake. In this case, clean the air intake or open it further.
What to do if the foam is too moist or there is too much foam in my Sera aquarium?
If the foam is too moist or there is too much foam in your Sera aquarium, it is likely that the water level within the unit is too high. To resolve this, place the skimmer in a higher position.
Why is there insufficient foam formation in my Sera aquarium?
Insufficient foam formation in your Sera aquarium is often due to an insufficient amount of air. Open the intake valve further to increase air flow.
How to fix dry or viscous foam in Sera aquariums?
If the foam in your Sera aquarium is too dry or very viscous, it could be caused by the water level within the unit being too low. Immerse the skimmer deeper. Another possible cause is insufficient pump performance. Clean the rotor, shaft, and intake nozzle.
How to fix insufficient air intake rate in Sera PS 130?
An insufficient air intake rate in your Sera aquarium could be due to several reasons: * The intake valve may not be opened sufficiently – open the intake valve further. * The air hose may be encrusted with lime or is dirty – clean the air hose. * The intake nozzle on the pump may be dirty – clean the intake nozzle. * The pump performance may be too low – clean the rotor and shaft.
Describes the role of the skimmer in removing proteins and particles from marine aquariums.
Explains how the dispergator pump draws air, mixes it with water, and forms foam for removal.
Details the steps for assembling the protein skimmer unit, including component identification.
Guides on starting the skimmer, adjusting foam, and initial setup for optimal performance.
Provides instructions for regular cleaning of the flotate cup and the entire skimmer unit.
Lists common problems, their possible causes, and solutions for the protein skimmer.
Outlines essential safety rules for operating and handling electrical aquarium equipment.
Lists key technical specifications including dimensions, pump details, and protection classification.
Identifies available spare parts for the protein skimmer with their corresponding item numbers.
Covers important warnings for users, appliance disposal, and WEEE regulations.
Details the warranty period and conditions for the sera marin Protein Skimmer PS 130.
To Next Page
General
