30
E. BATTERY AND ELECTROLYTE INSPECTION:
• This series use M/F Battery so you do not have to inspect electrolyte.
NOTICE:
• Absolutely do not open the lid of battery.
• Battery may produce ammable air. Take care of tire when install or remove.
• If not used for a long time, battery may self- discharge. To prevent the leak of electricity recharge battery rst and place if at a cool place. If
battery is kept on the motorcycle, disconnect negative terminal.
F. FUSE REPLACEMENT:
REMOVE:
• Turn out the cap of fuse case and take out the fuse.
• If fuse connection is not good, the fuse overheat and breakdown.
INSTALL:
• Install the fuse into fuse case and fasten the cap.
• Try to pull the fuse after install. If loose, the fuse will overheat and breakdown
NOTICE:
• Do not use any fuse whose specication is different form assigned. It is the main reason for wiring burning.
• If cannot nd out the reason, deliver the motorcycle to the distributor or service center for inspection and repair.
• Do not use high pressured water to wash around the side cover.
To Next Page
Loading...
