3019 Alvin DeVane Boulevard, Suite 560 • Austin, Texas 78741 USA
Ph (650) 965-8020 Fax (650) 965-1193
900 Series Wireless Headsets: Third and Fourth Generation
User Guide
1.0 GENERAL
Before using your wireless headset, read these instructions carefully.
Each 900 Series Wireless Headset comes as a kit which includes the following components:
- wireless headset (Fig. 1);
- Base Station (Fig. 2);
- two power cables, one to charge the headset and one to power the Base Station (part number: 25-1004);
- one headset hanger for the headset (part number: 14-7014);
- four mounting screws for the Base Station (part number: 21-8006);
- two screw-on Headset Antennas (one is included with headset, one with base – Fig. 1 [g]; part number: 28-2017)
Please confirm that you have received all of these components.
Confirm that the headset is fully charged (See 2.1 below) and that the Base Station is powered.
Note: these instructions cover Setcom’s third generation of 900 Series wireless headsets. If you received your headset prior to
April 2012, you have Setcom’s second generation wireless headset, which functions identically to the third generation, only
without the Cell Phone Button (Fig. 1 [h]) and optional cell phone interface capability.
Note: if you received your headset prior to March 2011, you have Setcom’s first generation wireless headset, which functions
differently than the second and third generations and has its own user guide. Please refer to this document for further information
on its use and operation.
2.0 HEADSET OPERATION
2.1 Charging
Plug Charging Cable (25-1004) into the headset’s Charging Jack (Fig. 1 [a]).
To fully charge the headset takes approximately 3.5 hours.
While the headset is being charged, its LED Indicator (Fig. 1 [b]) will show a steady amber color. The LED Indicator will go
off when the headset is fully charged.
The headset may be used while charging. In this case, the LED Indicator will show a steady amber color while also slowly
flashing green.
2.2 Turning the Headset On and Off
Locate the Volume Control (Fig. 1 [c]) on the headset’s right cup: this is also the headset’s on-off switch.
Turn the knob clockwise to turn on the headset.
Immediately after being turned on, the headset will beep one-to-three times, indicating its battery charge level:
- One beep: Low battery/ charging required
- Two beeps: Moderate charge remaining
- Three beeps: Fully charged
The headset will link to the Base Station very quickly. Within about five seconds, the headset will beep three times, low-to-
high, indicating that it is linked.
To turn off the headset, turn the Volume Control counter-clockwise until it clicks.
To Next Page
Need help?
General