IMPORTANT SAFETY
AND
GROUNDING
I
NSTRUCTIONS
Safety and Compliance
1.Read
the
manual
before
installation or usage of
device.
2.Do not
put
tools, material or body
parts
into
the
electric
vehicle
connector.
3.Do not use
the
DC
Quick
EV
Charger
if
the
chassis,
power cord
or
charging
cable
are
frayed,
have
broken insulation, or
any
other
signs
of
damaged.
4.
Do not install or use
the
DC Quick EV Charger if the
enclosure
is
broken,
cracked,
open
or
has
any
other
indications
of
damage.
5.
The DC Quick EV
Charger
should
be
installed
only
by
a
qualified
technician.
6.
Make sure
that
the
materials used
and
the installation procedures
follow
local building
codes and
safety
standards.
7.
The information provided in this manual in no way exempts
the
user
of responsibility to
follow all applicable codes or
safety
standards.
8.
The manufacturer is
not
responsible for
physical
injury,
damage to property
or
equipment
caused
by the installation of this
device.
9.
This document
provides
instructions
for
the
DC
Quick EV Charger
and should
not
be used
for
any
other
product. Before installation or
use
of
this
product,
you should
review
this
manual carefully and consult
with
a
licensed
contractor,
licensed electrician,
or
trained
installation expert
to
make sure of compliance
with
local
building
codes
and
safety
standards.
Grounding
Instructions
An
equipment
grounding
conductor or a
grounded,
metal,
and
permanent
wiring
system
is
required
for
the
DC
Quick
Charger
connection.
This
should
be
run with circuit conductors
and
connected
to the equipment
grounding
bar or lead on the
DC
Quick
Charger.
Notes:
Do not install charging station in locations where it may be exposed to direct
sunlight and inclement weather. Recommend waterproof shed for EV
charger.
If the charging station is to be stored, keep it in its original packaging in an
appropriate place:
· On dry base ground
· Sheltered from dust, inclement weather, and sunlight;
· storage temperature: -30°C to 70°C
· Humidity: 5–95%
To Next Page
Loading...