SEVERIN 7023 - Troubleshooting Guide; Appliance Wont Switch On; Red LED Indicator

32
Troubleshooting
9 Troubleshooting
Using the table below, check whether you can remedy the problem:
Problem Possible cause/Remedy
Appliance can-
not be
switched on.
Rechargeable battery is completely discharged.
Switch off the appliance (position "0") and charge rechargeable battery, page
26, “Recharging the rechargeable battery”.
Appliance was switched on during charging (position "I").
Use the on/off switch to switch the appliance off (position "0") and then on again
(position "I"). The appliance then starts up.
Cover was removed while the appliance was still switched on.
Use the on/off switch to switch the appliance off (position "0") and then on again
(position "I"). The appliance then starts up.
Cover is not fitted correctly. Switch off the appliance (position "0") and put the
cover on again.
LED " "
lights up red.
Rechargeable battery must be charged.
Switch off the appliance (position "0") and charge rechargeable battery,
page 26, “Recharging the rechargeable battery”.
The drop sensors are set unevenly.
Set all 3 drop sensors to the same level, page 27, “Adjusting appliance for
floor”.
Drop sensors are not set correctly.
Adjust the drop sensors to the brightness of the floor and step height,
page 27, “Adjusting appliance for floor”.
Drop sensors are contaminated.
Clean the drop sensors, page 31, “Cleaning the drop sensors”.
Appliance is not in contact with the floor.
Place appliance on the floor. It now begins to clean right away.
RB7023.book Seite 32