SEVERIN CY7086 - User Manual

104 pages

Go to English

Save Page as PDF

To Next Page

DE Singlecyclone Bodenstaubsauger – Gebrauchsanleitung ..........2

Single-cyclone vacuum cleaner – Instruction manual .............. 14

Aspirateur traineau singlecyclonique – Mode d’emploi .............26

Singlecyclone vloerstofzuiger – Bedieningshandleiding ........... 38

Aspirador monociclón – Manual de instrucciones ....................50

Aspirapolvere monociclonico – Istruzioni per l’uso ................... 62

Singlecyclone-golvdammsugare – Bruksanvisning ..................74

 OdkurzaczSinglecyclone–Instrukcjaobsługi ..........................86

CY7086

www.severin.com

Main Page

Questions and Answers

M
Matthew FreemanAug 8, 2025
What to do if my SEVERIN CY7086 Ultrasonic Jewelry Cleaner suddenly stops?
- S
  Steve TrujilloAug 8, 2025
  If your SEVERIN Ultrasonic Jewelry Cleaner suddenly stops, it's likely due to the integrated overheating protection being activated, possibly from an overfilled dust container or filter. To resolve this: 1. Switch off the appliance. 2. Disconnect the plug from the socket. 3. Address the overheating cause by either emptying the dust container or cleaning the filter. Also, check for and remove any clogs. Ensure you inspect the hose, nozzle, and telescopic tube for blockages. 4. Reassemble the appliance and reattach all accessories. 5. Allow approximately 45 minutes for cooling. Afterward, you can switch the appliance back on.
L
Laura JoyceAug 25, 2025
Why is my SEVERIN CY7086 Ultrasonic Jewelry Cleaner not picking up dirt well?
- R
  Robert SmithAug 25, 2025
  If your SEVERIN Ultrasonic Jewelry Cleaner isn't picking up dirt effectively or the suction power is noticeably reduced, there are several potential causes: * The attached nozzle might be unsuitable for the floor type. Select the correct nozzle for your floor. * The “carpet/hard floor” selector is in the wrong position for the floor type. Adjust the switch to the correct position. * The suction power setting may be inappropriate for the floor. Adjust the suction power to the correct setting. * The dust container may need emptying. Empty the dust container and consider cleaning the filters as well.