26
insTallinG anD charGinG ThE appliancE
3 Installing and charging the appliance
For additional installation tips, see Quick Start Guide Installation.
Installing the wall mount
1. Select an attachment location within drilling range of a socket.
2. Hold the wall mount to the wall,
aligned in a vertical position.
3. Mark the drilled holes with a
pencil.
4. Drill the holes (approximately 8
mm Ø).
5. Insert the dowels included in the
delivery into the holes.
6. Fasten the wall mount using the screws included in the delivery.
Charging the rechargeable battery
The rechargeable battery needs to be charged before rst use. It is best to charge the rechargeable battery
before each use, especially after the appliance has not been used for a while. This increases the service life of
the rechargeable battery and ensures the longest possible cleaning cycles.
1. Plug the connector for the mains adapter included in the delivery into the connection socket on the
rechargeable battery.
2. Connect the mains adapter included in the delivery to a socket.
The LEDs on the rechargeable battery start to ash. The charging process starts. The more the LEDs
ash, the more advanced the charging process is.
The LEDs go out once the rechargeable battery is fully charged. The charging process takes around 3
hours when the rechargeable battery is empty.
3. Disconnect the mains adapter from the socket.
4. Disconnect the mains adapter’s connector from the connection socket on the appliance.
TIP: The operating time with a fully charged rechargeable battery is approx. 10 minutes (in Power
mode), approx. 30 minutes (in Middle mode) or approx. 60 minutes (in Eco mode).
For further information, see also illustrated Quick Start Guide.
1
To Next Page
Loading...
