SG 600 - Installing the Curtain

Installing the Curtain
Installing the curtain involves the following tasks:
° Attach J-clips: Magnetic curtain setting brackets, called J-clips, attach to the
rails or frame.
° Set the curtain: Support the curtain with the J-clips while you position the top
bar inside the housing.
° Attach the threshold cables: Drop two Kevlar cables wrapped inside the
housing and attach them to the threshold spools while the curtain rests on the
J clips.
° Position and secure the curtain: Use a jogger (provided by Smoke Guard
to certified installers) to position the curtain.
NOTE: If possible, two people should set the curtain on the rails to reduce the chance of
damaging the curtain.
Model 600 component: curtain assembly
Tools/Materials:
° 2 J-clips
° jogger
° safety glasses
° hand drill
° 5/16” hex driver
° drill point screws
(provided)
° 120 VAC extension cord
with ground
To attach J-clips: Position magnetic J-clips against the rails at bottom of the housing.
° line up the tops evenly with each other, at least two inches below the
housing
° line up the J portion on the outside edge of the rail:
CAUTION: Clean the magnets on the J-clips of debris to
avoid scraping the frame. Attach and remove carefully.
17