28
RDM
The P-1 features support for various RDM functions.
RDM (Remote Device Management) is a protocol enhancement to USITT DMX512 that allows bi-directional communication
between the fixtures and the controller over a standard DMX line. This protocol will allow configuration, status monitoring, and
management. See the table below for supported RDM functions.
The controller communicates with the fixtures to show only the available options for each RDM function.
The P-1 supports and enable RDM, Remote Device Management, as per the ANSI E1.20 standard.
PID
Actions
Allowed
Name PID
Actions
Allowed
Name
0x00F0 GET SET DMX Start Address 0x0080 GET Device Model Description
0x00E0 GET SET DMX Personality / Mode 0x0400 GET SET Device Hours
0x00E1 GET DMX Personality Description 0x0051 GET Parameter Description
0x1000 GET SET Identify 0x0501 GET SET Display Level, 0=OFF, 1 and above=ON
0x1001 SET Reset Device 0x0500 GET SET Display Invert
0x0200 GET Sensor Definition 0x8626 SET CRMX Log Off
0x0201 GET SET Sensor Value
0x8631 GET SET Battery Extension Hours
0x0082 GET SET Device Label 0x0090 SET Factory Defaults
0x0081 GET Manufacturer Label
0x8060 GET Serial Number
To Next Page
Loading...
