SGS SCT501 - Operation and Adjustments; Throttle and Idling Speed Adjustment

PAGE 33
ADJUSTING THROTTLE CABLE
The normal play is 1 or 2 mm when measured at the carburetor
side end. Readjust with the cable adjuster as required.
ADJUSTING IDLING SPEED
Warm up the engine before adjusting the idling speed.
OPERATION
1) Cable adjuster
1-2mm
(1) Idle
adjusting
screw
1. If the engine stops frequently
at idling mode, turn the adjusting
screw clockwise.
2. When the cutting head keeps
rotating after releasing
the trigger, turn the adjusting
screw counter-clockwise.
ZZ
NOTE