PAGE 36
OPERATION
OPERATION
1. Check the bolt to fasten the blade and be sure the
bolt has no fault, and no abrasion.
2. Be sure that the blade and the holder have been
fastened according to the instructions and that the blade turns
smoothly without abnormal noise.
• The rotating parts fastened incorrectly may cause serious ac-
cident to the operator.
• Make sure that the blade is not bent, warped,cracked,
broken or damaged.
• If you find any damage to the blade, discard it and replace
with a new one.
By using the shoulder strap, hang the
unit on your right side. Adjust the
strap length so that the cutting head
is parallel to the ground.
To Next Page
Loading...