Shanling CA80 - Page 12

Volume Control
Press the [VOL +/- ] buttons on machine or remote control to increase or decrease the volume.
12
Operating instructions
Turn ON/OFF
1. Connect the power cord and signal cable of the .machine
5. Put the power button on the rear side into OFF position to completely power off the .machine
Select Input Source
Pause Playback
Previous Track
Press the [ ] button on or remote. If the current track played for less than 10 seconds, it will
switch to previous track. If the current track played for more than 10 seconds, it will jump to the
beginning of the current track. Press the button again to switch to previous track.
machine
Next Track
Press the [ ] button on or remote to switch to the next track.machine
Stop & Eject
CA80
The Music Centre
2. Put the power button on the rear side of the player into On position. Indicator on display should turn
red.
3. Press the [ ] button for 2 seconds to turn on the device. /SOURCE
4. Long press the [ ] button for 2 seconds to turn off the device, power indicator will turn red. /SOURCE
Press the [ ] button on the device or the [ INPUT ] buttons on the remote to switch between
inputs. "AUX CD BT ".
/SOURCE
、 、 、
1. Make sure device is set to CD Source mode.
2. Press the [ ] button on the device or on the remote to stop the playback, press it again to eject
the disk.
Press the [ ] button on the device or on the remote to pause the playback. Press the button again to
resume playback.