b. Install the USB Driver on the computer
before connecting player.
c. After connecting the player to a
computer, open "Sound " on your
computer, right click on "Shanling
audio device" and click "Set as Default
Communication Device".
How to download the USB driver:
V i s i t t h e M 0 p r o d u c t p a g e o n
to download the USB
driver.
www.shanling.com
Common Problems
1. It is recommended to use DC5V 2A adapter. Using the adapter with
higher voltage may damage M0.
2. Unable to start M0, it may be caused by low power or exhausted
battery, please recharge and then start up again.
3. In the case of system freezing or crashing, please press and hold the
Power button for 10 seconds to force a shutdown.
4. If there is noise from headphones, headphone's output interface may
not be connected correctly, please try to insert it again.
5. When there is no sound, try to use different pair of headphones or
different cable and make sure the system volume is set correctly.
Realtek High Definition Audio
Realtek High Definition Audio
Realtek Digital Output
Shanling Audio Device
Configure(C)
Amplifier
Ready
Ready
Default device
Amplifier
Select the following devices to modify the settings:
Sound
Set default(S)
Attribute(P)
OK Cancel
Apply(A)
Play Record Sound Communication