sharkclean.comsharkclean.com
NOTE: All accessories are compatible with both the wand and the handle.
WHOLE-HOME CLEANING
CLEANING MODES
To engage brushrolls, step on floor nozzle
and tilt handle back.
Press power button to turn on vacuum.
Please note the brushrolls will not spin
unless the wand is reclined.
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushrolls are spinning and working as they should.
Solid Red: There is a jam in the brushroll area. Turn o the vacuum and unplug it, then remove
any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn o the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
Press the Wand Release button to detach the
wand from the pod.
Thick Carpet & Area Rug Cleaning
Set surface selector to Thick Carpet/Area
Rug.
Carpet & Low Pile Cleaning
Set surface selector to Carpet/Low Pile to
increase the speed of the brushrolls and to
help remove stuck-on dust and debris.
Hard Floor Cleaning
Set surface selector to Hard Floor.
With pod removed, press the Wand Release
button to detach the wand from the floor
nozzle.
Press the Handle Release latch to detach the
handle from the wand.
Press the Lift-Away button to detach the pod
from the floor nozzle.
UPRIGHT
POWER SWITCH
INDICATOR LIGHT
ABOVE-FLOOR—HANDLE
LIFT-AWAY®
ABOVE-FLOOR—WAND
SURFACE SELECTOR
LIFT-AWAY®
WHOLE-HOME CLEANING
SETTINGS
BRUSHROLL INDICATOR LIGHT
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please set to Carpet/Low Pile. NOTE: For
particularly stubborn stuck-on dust messes, set to Carpet/Low Pile mode.
NOTE: The brushrolls will spin in all settings.
To Next Page
Loading...
Need help?
General
