15sharkclean.co.uk14 sharkclean.co.uk
USING YOUR VACUUM
To detach the floor nozzle from the wand,
step on the nozzle while pressing the
nozzle release button at the bottom of
the wand� Lift the wand to remove it� To
reattach the wand, align it over the neck
of the floor nozzle, then slide it on until it
clicks into place�
Detach the hand vacuum to clean above-
floor areas� Press the front latch release
button on the hand vac where it meets the
wand, then lift o the hand vacuum� To
attach an accessory to the hand vacuum,
slide it into the opening in the nozzle� To
remove, press the front latch release button
on the hand vac where it meets the wand,
and slide out the accessory�
ABOVE-FLOOR WITH WAND
ABOVE-FLOOR WITH HAND VACUUM
NOTE: All accessories are compatible with both the wand and the hand vacuum�
USING YOUR VACUUM
USING THE AUTO-EMPTY DOCK (IW3000 SERIES)
USING THE AUTO-EMPTY DOCK (IW3000 SERIES)
Place the vacuum on the dock in a downward
motion� Once properly attached, the
auto evacuation process will begin� The
evacuation cycle will last for 15 seconds�
Once evacuation is complete, the vacuum
will continue charging until it is removed
from the dock�
Note: do not remove the vacuum while the evacuation cycle is taking place.
Press the button on the top of the dock that
shows an image of a moon� This will initiate
Quiet Mode� When the dock is in Quiet Mode,
you can dock the vacuum without auto
evacuation occurring�
The Dust Bin Full indicator will illuminate
when the dust bin is full of debris and needs
to be emptied� To reset the indicator, remove
the dust bin and empty it�
QUIET MODE BUTTON LOCATION DUST BIN FULL INDICATOR
To Next Page
Loading...
Need help?
General
