13sharkclean.co.uk12 sharkclean.co.uk
MAINTAINING YOUR VACUUM
Press the wand release button to detach the
handheld vacuum from the wand�
To remove the dust cup from the handheld vacuum,
press the Dust Cup Release button near the handheld
vacuum nozzle� Tilt the dust cup and lift o to remove�
To empty dust and debris, hold the dust cup over
the bin, then slide the CleanTouch Dirt Ejector slider
forward�
To empty the Dust Cup while it is attached to the
handheld vacuum, position the dust cup over a bin
and slide the lid release slider forward�
To clean the interior of the dust cup, rinse it with
water� Place it on its side with the lid open to air-dry
for at least 24 hours before reinstalling�
REMOVING AND CLEANING THE DUST CUP
1
1
2
2
EMPTYING THE DUST CUP
MAINTAINING YOUR VACUUM
CLEANING THE FILTERS
Regularly rinse and reinstall the filters to maintain your vacuum’s suction power.
To clean filters, rinse them with water only� Allow all filters to air-dry completely before reinstalling to
prevent liquid from being drawn into electricparts�
Clean the pre-motor filters at least once a month and post-motor filter at least once a year� Tap o loose dirt
between washes when needed� More frequent cleaning may sometimes be necessary with heavy use�
IMPORTANT: DO NOT use soap when cleaning the filters� Use water only� The vacuum will not have suction if the post-motor
filter is not installed� Ensure that all filters are installed before using�
PRE-MOTOR FILTER POST-MOTOR FILTER
Press the dust cup release button and remove the
dust cup� Pull the foam and felt filters out of the
back of the dust cup�
Remove the dust cup� Pull the post-motor filter out
of the handheld vacuum�
Pre-Motor Foam and Felt Filter Kit Post-Motor Filter
To Next Page
Loading...
Need help?
General
