5www.sharkclean.com
English
1 To extend the power cord, pull it from the rear
of the vacuum to the desired length (Fig. 3). A
yellow mark on the power cord shows the ideal
cable length.
CAUTION: DO NOT pull the power cord beyond
the red mark on the power cord as this will
damage the cord.
2 Plug the vacuum into an electrical wall outlet.
3 Press the On/Off Button to the “On” position to
begin. (Fig. 4)
4 Press the On/Off Button to the “Off” position
when finished using the vacuum.
Using the Vacuum
5 To retract the power cord, press the cord rewind
button. (Fig. 5) If the cord does not fully retract,
pull it out a little and then press the rewind button
again.
WARNING: Always hold the plug and DO NOT
allow to whip when rewinding.
6 To store the canister vacuum, insert the clip that is
on the back of the air turbine floor nozzle or floor
brush into the slot on the back of the vacuum.
(Fig. 6)
Fig. 3
Fig. 4
Fig. 6
Fig. 5
To Next Page
Loading...
