15 16sharkclean.com sharkclean.com
ENGLISH
MAINTENANCE - Continued
Resetting the Motor
Thermostat
Your Shark Navigator® is
equipped with a protective
Motor Thermostat. If the
motor should overheat,
the thermostat shuts o
the power.
To order Additional Parts
& Accessories go to
sharkclean.com.
PART PART NO.
Stretch Hose 126FFJ
Multi-Tool 127FFJ
Foam & Felt Filter XFL100
Extension Wand 1116-FC
24” Crevice Tool 122FFJ
11” Crevice Tool 129FFJ
Pet/Upholstery Tool 128FFJ
Get even more cleaning from your Shark
Navigator
®
by checking out our cleaning
accessories at sharkclean.com.
Bookmark the page and check back often
to take advantage of the latest products,
promotions and prices!
ADDITIONAL ACCESSORIES (AVAILABLE FOR
PURCHASE):
MULTI-TOOL
Convenient crevice tool and dusting brush in one.
PET/UPHOLSTERY TOOL
Perfect for grabbing pet hair and lint from
furniture and other upholstered surfaces.
CREVICE TOOL
Clean in corners and other tight spaces or
reach baseboards and ceilings with this slim
crevice tool.
NOTE: Some accessories may be included with
your purchase.
TROUBLESHOOTING
WARNING: To reduce the risk of electric shock, the power cord must be
disconnected before performing maintenance/troubleshooting checks.
To purchase replacement parts, please visit our website: sharkclean�com�
PROBLEM POSSIBLE REASONS & SOLUTIONS
Vacuum will not run�
Check to see if the vacuum is plugged in properly.
Check the circuit breaker/fuse.
Check the On/O button.
Vacuum is not picking
up dirt�
Airflow is restricted�
No suction or light
suction�
Check filters to see if they need cleaning. Follow
instructions for rinsing and drying the filters before
reinserting back into the vacuum. (See Maintenance
section for instructions.)
Dust cup may be full; empty dust cup.
Check hose and hose connections for blockages; clear
blockages if required.
If dust cup is empty, and attachment inlets are clear,
check for other blockages. (See Checking for Blockages
for instructions.)
Brushroll does not
turn on�
Move the Brushroll button to the ON position.
The brushroll indicator light will illuminate green.
Place your foot on the power nozzle and tilt the handle
back to engage the brushroll.
If the brushroll indicator light on the nozzle is red,
see the Checking for Blockages section for more
information.
Vacuum turns o
on its own�
This vacuum cleaner is equipped with a motor-
protective thermostat. If for some reason your vacuum
overheats, the thermostat will automatically turn the unit
o. Should this occur, perform the following steps to
restart the motor thermostat:
1. Press the Power button to the OFF position.
2. Unplug the vacuum.
3. Empty the dust cup and clean filters.
(See Maintenance section for instructions.)
4. Check for blockages in hose, accessories, and
inlet openings. (See Checking for Blockages
for instructions.)
5. Allow the unit to cool for a minimum of 45 minutes.
6. Plug in the vacuum.
7. Press the Power button to the ON position to
restart the vacuum.
Note: If vacuum still does not start, contact Customer
Service at: 1-800-798-7398.